Give Your LightCam a Fresh Start
How to fully power-cycle your LightCam when a quick wall-switch flip isn't enough.
Give Your LightCam a Fresh Start
Sometimes your LightCam just needs a full reset — power completely off, everything cleared, and back on fresh. Here's how to do it right.
Why "flip the switch" sometimes isn't enough
A quick wall-switch flip can be too brief to fully reset the camera's network connection. The camera has a small amount of stored power that holds things in place for a second or two, and the connection state doesn't always clear. When that happens, the camera comes back on as if nothing happened — and the problem comes back with it.
The fix is a full twist-out. That cuts power completely and gives the camera time to fully reset before it starts back up.
How to give your LightCam a fresh start
- Twist the camera counter-clockwise until it comes fully out of the socket.
- Wait 30 seconds. This is the part that matters — give it time.
- Twist it back in clockwise until it's snug.
The camera will power on and reconnect to your network. Give it about 2 minutes. The light will turn solid white once it's back online.
Still offline after 2 minutes?
A few things to check:
- Your home WiFi is working (open a website on your phone to confirm)
- The wall switch for that fixture is turned on
- The camera is within good range of your router
If it's still not back, see Camera Went Offline — How to Get It Back for more steps.
Still need help? Email support@lightcam.com.
Still stuck?
Tell us what's going on and we'll write back.